跳转至

ISR4K16.05及以下版本许可说明

[思科] ISR4K路由器16.05.x以下版本许可说明

1. 在设备上生成请求代码并发送至供应商

登入设备,按照如下顺序输入指令,设备license UDI。将license UDI发送至供应商。

show license udi

2. 供应商返回许可文件

许可文件格式为XXXXXX_SN_FOC263XXXXX.lic。

3. 将许可文件导入设备并安装

将其存入U盘,插入到设备上。登入设备利用copy指令将许可文件复制到flash,再使用安装命令即可。

# copy许可文件到flash
copy usb0:FDOXXXXXXX.lic bootflash:/ 

# 安装许可
RouterA#license install bootflash:SERIAL_PLACEHOLDER_BOOST.lic

# 如下结果提示安装成功
•        Installing licenses from "flash:FDOXXXXXXX.lic" 
•        Installing...Feature:booster_performance...Successful:Not Supported
•        1/1 licenses were successfully installed 
•        0/1 licenses were existing licenses
•        0/1 licenses were failed to install

# 示例1:增加设备背板带宽
RouterB#show platform hardware throughput level                查看现有的背板带宽  
 The current throughput level is 100000kb
RouterB#
RouterA#configure terminal 
RouterA(config)#platform hardware throughput level ?                 可修改的背板带宽
 100000 throughput in kbps                                            100M
 300000 throughput in kbps                                            300M
 boost   Enables unthrottled throughput traffic                       无限制
RouterA(config)#platform hardware throughput level boost
RouterB#show platform hardware througevel              查看背板带宽已结果已为无限制
 The current throughput level is unthrottled    


# 示例2:配置启动时,激活的功能,例如uck9   
configure terminal
  license boot level uck9
end
# 保存,重启加载许可
write
reload